MEMS Tutorials

Build an Arduino ADXL345 I2C setup to read 3-axis acceleration and optionally calibrate offsets for more accurate mot...

Build an ESP32 AP Mode WiFi network that hosts a Hello World web page with no Internet required, a simple foundation ...

Build an ESP32 BMP280 sensor reader that prints pressure, temperature, and altitude to the Serial Monitor using the A...

Learn how Arduino and Raspberry Pi projects read pressure, humidity, and temperature from the BME280 using MEMS conce...

Build an Arduino Nano Every + MPU6050 I2C setup to stream accelerometer and gyroscope readings to the Serial Monitor,...

Build a Raspberry Pi Pico ADXL345 I2C accelerometer reader in MicroPython to print real-time X, Y, Z values in g for ...

Build an I2C environmental monitor by wiring a Seeed Studio XIAO RP2040 to a BME280 and printing temperature, humidit...

Connect an Arduino Uno to an MPU6050 over I2C and stream accelerometer and gyroscope readings in the Arduino IDE usin...

Build a Raspberry Pi Pico + BME280 CircuitPython project that prints temperature, humidity, pressure, and estimated a...

Learn how the MPU6050 MEMS sensor converts motion into capacitance changes for linear acceleration and gyroscope read...

Compare HC-SR04+ vs HC-SR04 to choose a 3.3V GPIO friendly ultrasonic distance sensor for boards like Raspberry Pi Pi...

Wire a Raspberry Pi Pico to a capacitive soil moisture sensor and read raw analog values, so you can calibrate later ...