Breadboard-to-PCB Bench Essentials Kit

Breadboard-to-PCB Bench Essentials Kit brings together the basic parts for developing your own low-voltage analog and digital circuits. Start on the 830-point solderless breadboard with 20cm Dupont jumpers, experiment with the resistor and electrolytic capacitor assortments, then transfer a checked design to the three 5 × 7cm copper prototype boards. Use the kit alongside your own Arduino, Raspberry Pi, ESP32 or other controller for sensor, robotics and general electronics projects. Permanent assembly requires soldering; a controller, power source and tools are not supplied as part of this component assortment.

Bundle value: Purchased separately, the included component variants total $34.47. This kit is $27.99, saving $6.48.

• 1 × 830-point solderless breadboard
• 1 × 120-piece, 20cm Dupont jumper wire set
• 1 × 820-piece resistor assortment: 41 values, 20 each, 1/4W, 1%
• 1 × 200-piece electrolytic capacitor assortment with storage box
• 1 × three-pack of 5 × 7cm copper prototype boards

This is a component assortment for your own circuit designs. Power sources, test equipment, soldering iron, solder and permanent hookup wire are not included. Permanent assembly requires soldering; observe capacitor polarity and the voltage rating of each component.

Read the kit setup guide for assembly planning, required extras and component references.